WHEEL SPACER KIT INSTALLATION INSTRUCTIONS

Congratulations for being selective enough to use Dinan Engineering Wheel Spacers. Dinan wheel spacer kit has been developed to eliminate balance problems associated with "universal wheel spacers". High quality materials and precision machining are utilized to assure that you will receive maximum performance and durability with minimum difficulty in installation.

1. Remove front wheels

2. Place wheel spacer on hub so that the countersink in the center pilot hole faces the brake rotor

3. Install front wheels on vehicle using the supplied longer lug bolts. Torque to 75-80 ft-lbs.

4. Remove rear wheels.

5. Install Dinan rear wheels on vehicle using the supplied stock-length lug bolts. Torque to 75-80 ft-lbs.

6. Verify that the proper clearance exists between the tire/rim assembly and all other components of the vehicle in proximity to the wheel. Check the following areas:

• Rim to strut tube.
• Tire to Fender lip.
• Tire to front and rear of fender well.
• Rim to Brake lines and sensor wires.
• Rim to suspension components in full lock, both directions.

These minimum clearances must be maintained throughout the travel of the suspension. Do not rely on the ride height of the vehicle when stationary to provide the appropriate clearance. The suspension will bottom out regardless of the spring rate you are running. Clearance must exist or damage to the vehicle will occur.