PLEASE NOTE: In most cases, all bulbs are initially set to an optimal operating angle and adjustment is not always required. Adjusted bulb angles have a direct impact on driving safety. Proper headlight adjustment is critical both for your vehicle and oncoming vehicles.
On these bulbs, you can easily adjust the angles specifically for the lights of your vehicle.
STEP 1. To adjust the bulb angle, unscrew the fixing bolts with an Allen wrench (included with the kit).
NOTE! The fixing bolts do not need to be removed, just loosened.
STEP 2. Rotate the bulb relative to the lamp base.
Caution! Be careful when adjusting the bulb angle since maladjustment may cause blurry cut-off line and unfocused low and high light beams.
STEP 3. Tighten the fixing screws with the wrench only after you've made sure that the angle is set correctly.
STEP 4. The bulb is adjusted and can be reinstalled in the lamp.
Caution! Recommended to adjust bulb angles only if absolutely necessary
The Bulb heat sink ensures heat dissipation and ensures the long-term operation of the bulb.
Sometimes there is not enough space for installing the bulb with the heat sink or a lamp dust cap doesn't close. In this case a reversible heat sink is used since it can be removed and reversed.
STEP 1. To remove the heatsink, first unscrew fixing bolts with a wrench (comes with the bulbs).
NOTE! The fixing bolts do not need to be removed, just loosened.
STEP 2. Unscrew and remove the aluminum heat sink from the bulb.
Caution!
A. Be careful not to damage the bulb power wire.
B. Do not touch the threads as they have thermal paste and this can negatively influence heat dissipation.
STEP 3. You may find on some installations that securing the bulb retaining clip is easier with the heat sink removed. In these cases, install the clip, then reinstall the heat sink. If a lamp dust cap doesn't close after bulb installation, reverse the installation of the heat sink.
This will reduce the overall length and make it possible to install the dust cap of lesser diameter.
NOTE! In both cases, be sure to tighten the fixing bolts.
The removable and reversible heat sink solves the problem of the bulb fitting in tight spaces and helps avoid the necessity for construction modification of the lamp assembly.