Get To Know SAA Products
This is the place to learn all about QAA's products and where they go. The illustrations below are intended to help and guide you in your buying decision. The illustrations are for customer education purposes only and does not imply that every vehicle will have all the listed trim.
Gas cap door cover is laser cut for a precise fit and finish. The trim piece does not replace your existing gas door; it installs directly on your gas door and gives it a chrome look. This makes the installation easy and can be done by the average consumer.
License Plate Trim
This trim piece varies in size and shape and typically installs behind the license plate. It will improve on the look of car and prevent scratches to the paint from a loose or vibrating license plates. Most installations are simple and do not require any screws.
License plate trim should not be confused with trim that looks like a picture frame and goes around the license plate.
Pillar post trim is installed on the pillars of the car. SAA pillar post trim is made using high quality mirror polished stainless steel and gives you the look of chrome.
Diagram Key:
P - Passenger
D - Driver
F - Front
R - Rear
Rear Bumper Cover
The rear bumper cover installs on the topside of the bumper. It serves a dual purpose of offering protecting the paint from scratches and it also serves as an elegant chrome like accent trim. Please note that trim will get scratched.
Trunk Lid Trim / Rear Hatch Lid
The trunk lid trim installs directly on the bottom of the trunk. This trim varies in width and length according to the design of the vehicle.
The rear hatch lid will go on trucks, SUVs or hatchback models in a similar location.
Rocker panel trim comes in many shapes and sizes depending on your make and model.
The diagram illustrates the type and placement of each rocker panel trim we carry.
I - Molding Trim: Either goes over existing molding or as to the doors
L - Lower Kit: Installs on bottom of doors and measures up a specified width
O - On Rocker Kit: Installs directly onto rocker
U - Upper Kit: Installs below molding, goes down specified width
F - Full Kit: Measures from the bottom off molding to bottom of door
Window sill trim are will vary in style, number of pieces and design depending on the vehicle. Some will have a 90 degree bend that makes contact with the top and side of the window sill. Others may just adhere to the side of the window sill.
Wheel well trim comes in two different styles:
- The first style is molded to the shape of the fender. It typically has a relieved profile and is wider in the middle and tapers on the ends. This style is installed using locking tabs and/or screws. A black rubber gasket is placed on the outer edge to prevent scratches.
- The second style is a flat piece usually about 3/4” wide. This style is installed with the help of 3M adhesive foam tape. The trim is almost flush with the car and has a very low profile. Some also have a black rubber outer lining for added visibility.
Features:
Boosts the look of any vehicle instantly!
Does not require any drilling, screwing or additional tools
Will match the existing chrome trim on your car
Uses 3M adhesive for easy installation
Finished with triple chrome coating for superior shine
The trim piece does not replace your existing door handle; it installs directly on your door handle and gives it a chrome look.