Planet Audio® MB1200.1D - Mini Bang Series 1200W Mono Class D Amplifier

2 reviews|Item # mpn4696825242
Universal Fit
Fitment notes:
  • Not Vehicle Specific
Authorized Dealer
$129.99
In Stock (3) - Ships Tomorrow 06.23.26
Have a Question? Ask a Specialist
888-903-4343Live Chat

Vehicle Fitment

This part is universal

Specifications

Channel Configuration
1 Channel
Power Supply Type
MOSFET Power Supply
Amp Topology
Monoblock Class D
Total Power Output
1200 W
Peak Power @ 1 Ohm
1200 W x 1
Peak Power @ 2 Ohm
600 W x 1
RMS Power @ 4 Ohm
225 W x 1
Speaker Impedance
1 to 8 Ohm
S/N Ratio (A-Weighted)
103 dB
Frequency Response
9 Hz to 50 kHz +/-1 dB
RCA Inputs
2 Channel
High Level Inputs
Yes
Low Pass Filter
50 Hz to 250 Hz
High-Pass Filter
Fixed
Subsonic Filter
15 Hz to 40 Hz
Bass Boost
Variable 0 to 12 dB
Subwoofer Level Control
Yes
Input Sensitivity Switch
Yes
Thermal/Overload/Short Protection
Yes
Dimensions
7.57" L x 5.12" W x 1.7" H

Features

  • 1 Ohm Stable - The lowest impedance accepted by this amplifier is 1 Ohm. Amplifiers that are 1 Ohm stable produce the most power possible from the amp. An amplifier capable of delivering power at a 1 Ohm load is usually reserved for serious subwoofers that can handle the power
  • Class D Amps - Class D is a high speed switching amplifier technology that is more efficient, generates less heat and draws less power than traditional Class A/B amps. Planet Audio use Class D in monoblock amplifiers to give you massive amounts of power in a relatively small footprint for clean, powerful, bass
  • Fixed High Pass Filter - Fixed High-pass filter gives you the ability to filter the frequencies that pass through to the full range speakers from a fixed frequency point
  • High and Low Level Inputs - An amplifier with both high-level and low-level inputs provides flexibility by allowing you to build an audio system using virtually any standard factory or aftermarket source unit. High-level (speaker level) inputs accept the signal from the speakers, while low-level (RCA) inputs accept the signal from the pre-amp outputs of the source unit
  • Protection - If the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself
  • Subsonic Filter - A subsonic filter is designed for use on subwoofers. Since not all subwoofers can reproduce the same low frequencies, the subsonic filter can be set for optimum bass response in order to keep the driver playing efficiently
  • Subwoofer Level Control - The ability to boost or attenuate the sub level when an amp and subwoofer are connected to the subwoofer pre-amp output
  • Switchable Input Sensitivity - Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed
  • Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it
  • Variable Gain Control - Variable Gain Control lets you balance the amps output with the speakers or subs the amp is driving. To much gain will lead to distortion and to little will lead to clipping
  • Variable Low Pass Filter - Variable low-pass filter gives you control over the frequencies that pass through to the subwoofer.

Product Details

Mini Bang Series 1200W Mono Class D Amplifier by Planet Audio®. Boost that bass with this high-end amplifier from Planet Audio. Combining cutting-edge technology with a sleek design, this extremely powerful amp is a perfect tune-up for your car sound system. It has a MOSFET power supply feature which allows to provide high power with minimum distortion. This amp is sure to improve sound quality so your music will play loud and clear through your sound system.

Part Number:
MB1200.1D
UPC:
636210107217
Alternate MPN:
MB12001D

Reviews

(2)
Only authorized customers can leave a review on our website. We would love to know what you like or dislike about the product. Share your opinion on product quality, appearance, installation, and other characteristics.
/5
1-2 of 2 Reviews
5 of 5
Great Entry Level Sub Amp!
This is not a competition amp! Plain and simple it's a entry level amp that will sound great if used properly. Don't just crank up every dial and overheat it or trip the protection circuit....it's not a nuclear power plant it has limits. I have it running 1 dvc 12'' planet audio ac12d (1800 watt) but wired it for home use with switched power supply with inline fuse. Couldn't be happier with the output and cool temps so far. Will post a reply upon any issues or failures, but so far so good!
Posted by Chris (Walbridge, OH) / April 12, 2020
5 of 5
Like it
This is a pretty good amplifier for the price. If you feed it with enough power it will provide the rated 4000 watts. This amplifier pushes the subwoofers with ease.
Posted by Tatiana (Tomball, TX) / December 12, 2013

Questions and Answers

(0)
If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!