Planet Audio® PL3000.1D - Pulse Series 3000W Mono Class D Amplifier

Features

• 1 Ohm Stable - The lowest impedance accepted by this amplifier is 1 Ohm. Amplifiers that are 1 Ohm stable produce the most power possible from the amp. An amplifier capable of delivering power at a 1 Ohm load is usually reserved for serious subwoofers that can handle the power
• Class D Amps - Class D is a high speed switching amplifier technology that is more efficient, generates less heat and draws less power than traditional Class A/B amps. Planet Audio use Class D in monoblock amplifiers to give you massive amounts of power in a relatively small footprint for clean, powerful, bass
• Protection - f the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself
• Strapping Capability - Strapping capability means that two amplifiers can be linked together to create double the power at an impedance of 2 Ohms. A benefit of strapping is less electrical current is required than if you ran [2] individual amps at 1 Ohm and you only need 1 pair of preamp outputs and RCA cable to connect
• Subsonic Filter - A subsonic filter is designed for use on subwoofers. Since not all subwoofers can reproduce the same low frequencies, the subsonic filter can be set for optimum bass response in order to keep the driver playing efficiently
• Subwoofer Level Control - The ability to boost or attenuate the sub level when an amp and subwoofer are connected to the subwoofer pre-amp output
• Switchable Input Sensitivity - Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed
• Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it
• Variable Gain Control - Variable Gain Control lets you balance the amps output with the speakers or subs the amp is driving. To much gain will lead to distortion and to little will lead to clipping
• Variable Low Pass Filter - Variable low-pass filter gives you control over the frequencies that pass through to the subwoofer.

Product Details

Pulse Series 3000W Mono Class D Amplifier by Planet Audio®. Boost that bass with this high-end amplifier from Planet Audio. Combining cutting-edge technology with a sleek design, this extremely powerful amp is a perfect tune-up for your car sound system. It has a MOSFET power supply feature which allows to provide high power with minimum distortion. This amp is sure to improve sound quality so your music will play loud and clear through your sound system.