Rek Gen® - Rek-Mesh Baja Black Mud Flaps with Plate and Logo

I honestly expected a lot better craftmanship for such pricey flaps. Every inch of these have machine marks where they were cut off out. I may have to just sand them out myself. Kinda disappointed.

They look good on my car. Instructions could use more details or video for easier installation. I had to drill two holes for the rear flaps as my car didn’t have the second hole from the top in the wheel well.

My first purchase for my 2016 Subaru WRX. I was very skeptical about the installation. I watched videos and was still unsure about it. When I got them, I immediately installed them. I took my driver tire of (like the videos showed) and then installed my first flap (by myself). I then realized, I don't need to take the tires off. I jsut need to crank the steering wheel the opposite way to have space to work with the wheel well. It was super easy once I figured the first flap out. It took me about an hour total. It was simple with the parts that came with. And it looks great! I get so many compliments on it. I would definitely recommend it to anyone who is looking for mudflaps. -N

Fácil de instalar.

Put these on my new 2019 WRX and the look really nice. They stick out a bit more than I think they should (about an inch and a half) but doesn't look bad. I did not receive an installation guide which was annoying, wasn't sure how some hardware was intended to be applied. But in the end figured it out and happy with the overall product so far.

Not sure about snow and ice buildup behind the flap inside the wheel well because it’s not molded to fender. We’ll see!

The mudflaps are a nice addition to my car. 2013 focus ST. The mudflaps are great quality, but I would recommend purchasing brackets for installing on the rear of the car. This product does not come with hardware, and it is difficult to install if you don’t go to Lowe’s or Home Depot to pick up some of your own hardware. Overall they seem like a pretty good product!

Very happy with product. Helps keep dirt off hatchback. Metal clips would be better.

I put these on my Tacoma, they were a breeze to install. Ten minutes per flap to take off the original screws, get the flap in place, tighten up, and get into final position. They will shift a bit as you tighten the screws, I used a level along the bottom to make sure each flap was straight. I also used satin black Rust-Oleum on the screws and washers for a nicer look, it would be nice if Rek Gen used black hardware for attaching the flaps.

Looks very good on my 2018 Toyota Tacoma. Very good quality. The installation for this one is kinda complicated needed some drilling, I didn’t have the tools for it, but when brought it to the autoshop about almost an hour was ready to go.