U.S. RACK® 82310041 - Crosstopper Truck Rack

When you watch the video, you will see them use a track bolt to install the cross bar. However, when you get the product it will be a round one that will spin when you put pressure to the nut. To solve, put the bar on the ground or a table. Start the nut and then lift up so gravity pulls the bar tight and locks the bolt so it will not turn. Once you have it semi -tight so you can still slide the leg on the cross bar to adjust for alignment then you will be able to tighten once you put it on the truck base posts. Barely clears my cab on my Tundra crew cab limited trd model. Noodles zip tied cross bar give the extra clearance. I have a sunroof so it has a hump on the cab.

I had this rack-mounted on the Snugtop cab High fiberglass camper shell of my 06 2500 HD Chevy. Even though my cap was slightly shorter than recommended for the full size rack, I was able to cantilever the rack over the cab just a bit due to the versatility of this rack, and makes it look sharp. It had been on my truck for over 10 years and I used it regularly. When loading it up at the lumber yard I often get the comment, "nice rack" and a lot of inquiries about where I got it. When hunting and camping, I fasten a full sheet of plywood to the rack and can use it to sleep on and as a raised platform to glass for game. The rack does rattle a bit, but I managed to quiet most of it down with creative use of rubber strips and silicone caulking. The rack can easily hold the 250lbs it's rated for, but the load needs to be distributed properly to keep from damaging it. The finish could be more rugged, it faded and can be worn off. Even though we get very little rain in Arizona, it did leave slight but noticeable, rust stains on my white cap. Despite any negatives, I recently sold the truck and cap, but removed the rack to use on my new Ram.

I’m glad that I got this rack. Versatile and durable. Now I can easily carry my canoe for vacation as well as transport loads to my work. The whole construction doesn’t weigh much. It takes minutes to install. When not used, I simply disassemble the rack and leave it in a garage (it doesn’t take much room).