Spyder® PRO-JH-FEDGE11-LB-C - Driver and Passenger Side Chrome LED DRL Bar Projector Headlights

Installed on 2012 Ford Edge and you cannot get to the adjustment screw for low beams without removing front bumper cover or wheel well liner. Factory can be done from above, but you cannot get to the adjustment screw on these aftermarket without it becoming a pain in the neck. They look good, but adjustment is a joke.

Installed on 2012 Ford Edge, the adjustment for the low beam is impossible to get to without removing front bumper assembly or removing wheel well liner and wheel. Factory headlight adjustment can be done from the top, these cannot. They look good, but adjustment is a joke.

I purchased these for my wife's 2011 Edge Sport. They look great on the car but this comes with a few major flaws. First was the passenger side headlight plug. The plug for the headlight would not plug in and snap. I tried multiple times and even confirmed the original still plugged in. After further investigation it was found that the headlight assembly tabs inside the new headlight were protruding too far and stopping the plug from fully engaging. I had to notch both sides of the factory plug to get the plug fully seated. Only the passenger side had this issue luckily. The other plug on passenger side actually bottoms out on the body of car when you tighten the headlight assembly. This causes two issues. One this cannot be good longterm for the plug when car vibrates going down the road. And there is absolutely no way of changing the bulb without removing headlight again. This is true for all bulbs though. None are serviceable with headlight assembly in the car. Make sure everything is plugged in before installing headlights, you cannot plug in the plugs after they are installed. I actually had to remove one of the harness brackets so the drivers side lug would fit. It was as tight as guitar string when I tried to tighten all the screws And now for the number one major flaw, you cannot adjust the low beams without removing the headlights, adjusting, then assemble again. This process will need repeated until the headlights are aimed. Looking back I should have done all the aiming with the bumper off but time did not allow me too wait until nighttime to put the car back together. The instructions say nothing about this, actually there are no instructions for specific vehicles. Only instructions are on this website and they basically say remove anything in the way of removing headlights. I would encourage anyone to stay away from these. This is so frustrating that a company can get away with producing such junk.

The headlights are just beautiful! High-quality product! Nor any flaws are installed very simply. Delivery ahead of schedule! Thanks! Very satisfied with the services of the TRUCKiD company!

Headlights are super! Very high-quality product! Everything works perfectly. The goods arrived very quickly. Quality packaged. Recommend!

It is nice to have GMC parts that keep evolving . I put these LED headlights on my 2014 GMC Terrain and what a difference ! The front end pops with a dynamic look along with the new grill I got as well...5 stars !

I'm impressed with the quality of these headlights. They fit perfectly and was easy to install. I did bit of research on this company and came to find out the components used comes from same factory as Morimoto. Worth every penny!

I am very impressed with the way this turned out and thankful to the lord Jesus because I could not see out of my stock headlights that had discolored. I am also grateful for the price, because other locations, including the dealership, were looking to charge over a $1000 for standard lighting, not upgrades such as this.

I received these in 2 days. I had them installed in less than 20 minutes and they perform perfectly. The H1 highbeams were included, I'm not sure why it says they're not included.

Look great on truck, easy to install.